• SDS+ Drill Bits
• Air Tank 120psi
• Industrial Interchange to Schrader Fitting Adapter
• Blow Gun Assembly
• Air Tank Conversion Kit

Rotary Hammer Drills are the best tools for drilling holes required by Micro-Blaster System in both concrete and stone. Tools labeled "Hammer Drills" and having a 3 jaw chuck should be avoided as they will take many times longer to establish the required holes. Make sure the drill you intend to use takes a SDS+ shank drill bit and use only 5/16 inch diameter drill bits with your Micro-Blaster System. We do not offer a rotary hammer drill at this time but they are available on the market.

Many of our customers have had problems finding the proper 5/16" dia. drill bits for their Micro-Blaster Systems. We now stock 2 models which will produce the required holes. The shorter of the 2 models shown above will drill up to 12" deep holes for double cartridge shots and is marked with a red stripe at 10" from the tip for single cartridge shots. The longer bit pictured has the capability of drilling up to 16" deep which will allow users the option of using 1, 2, 3, or up to 4 cartridges per shot. This bit also has a longer lasting carbide tip which should give excellent service in even the hardest materials.

When charged with 120 psi of air will reliably trigger three Micro-Blaster II Heads simultaneously. Easily recharged in the field with Bicycle Tire Pumps between shots and provides extreme portability for working in remote areas. Materials: Powder Coated Steel Tank, Brass Fittings. Dimensions Overall: 8"Lx6”Dx7.25"H (228x152x184mm) Max Pressure: 150 psi Max. Capacity: 0.5 Gal. Weight: 4 lbs.

This adapter will allow the firing of a single Micro-Blaster IIx3 head from an air source using a Schrader type chuck commonly found on tire filling devices. Portable air tanks, T handle bicycle pumps, CO2 inflators are common examples. Complete with Dust Cap.

Other than drilling, the most tedious aspect to using your Micro-Blaster is the hole cleaning process. To speed up this operation we have developed the blow gun assembly seen above. Equipped with a 1/4" quick connect plug (Industrial Interchange, same as our manifold hose connector), a 5 ft. air hose, a lever valve and a 9.5" long, 1/4" dia. stainless tube, the unit will quickly and thoroughly clear the dust from drilled holes in just one or two seconds. Since its use is intermittent only a small compressor, capable of 100 psi output, is required for operation.

!!! SAFETY NOTICE !!!  THIS BLOW GUN ASSEMBLY IS NOT OSHA COMPLIANT AS IT DOES NOT LIMIT PRESSURE AT THE NOZZLE TO 30 PSI.  CARE SHOULD BE USED NOT TO DIRECT OUTPUT AT PERSONNEL.  ALWAYS WEAR APPROVED EYE PROTECTION WHEN USING THIS AND OTHER EZEBREAK PRODUCTS WORK SAFELY AND CRACK WISELY!

If you already have your own air tank you may need components to connect the Micro-Blaster to your tank. For your convenience we have put together a kit containing the above components. Ask your Dealer or Ezebreak for the Air Tank Conversion Kit (Part# MBIIx3-ATCK) if you cannot easily find these components locally.  Click HERE for detailed instructions and tips.